About midnight (we were outdoors closing up), watcher reported an error on i+trim2 for CCD61. Here is the output from cc 61 vcheck: im> cc 61 vcheck BIAS BOARD VOLTAGES SIGNAL DAC SET MEASURED NOM TOL READ LN2TEMP NONE THIS CAM HEATERV NONE THIS CAM CCDTEMP NONE THIS CAM TSET 47 -3.21 V -3.10 V 348 7 353 TZERO 128 0.00 V 0.04 V 512 5 514 I-TRIM2 255 5.02 V 5.00 V 768 10 768 I-TRIM1 255 5.02 V 5.00 V 768 5 768 I+TRIM2 10 -4.67 V -6.68 V* 274 5 169* I+TRIM1 10 -4.67 V -4.61 V 274 5 276 VSW- 127 -5.00 V -4.94 V 256 10 259 VLG 101 -6.01 V -5.90 V 204 10 210 VT- 101 -6.01 V -5.92 V 204 10 209 VT+ 177 6.99 V 7.00 V 868 5 870 VP3- 88 -6.51 V -6.40 V 180 10 184 VP12- 88 -6.51 V -6.40 V 180 10 184 VP3+ 139 5.49 V 5.47 V 792 5 792 VP12+ 139 5.49 V 5.49 V 792 5 792 VS- 127 -5.00 V -4.92 V 256 10 259 VS+ 177 6.99 V 7.00 V 868 5 870 VR 45 11.98 V 11.96 V 817 7 817 VRD2 223 13.99 V 13.99 V 870 5 870 VRD1 223 13.99 V 13.99 V 870 5 870 VDD2 236 24.30 V 24.24 V 923 7 923 VDD1 236 24.30 V 24.42 V 923 7 926 We issued an iack. Another cc 61 vcheck immediately after showed the same state. We waited the canonical 6 minutes for cam check to work round the camera. Menawhile, Jurek's sop session (xterm and GUI) and telrun had hung. We were not sure if the spectrographs had been left in an indeterminate state, so Pete issued commands in his sop window, getting an error: sp2> initNight Tue Aug 14 00:40:35 MDT 2001: SOP Ready for flight rpc.pcnfsd appears to be running - good. nfsd appears to be registered - good. sp2> goStare 0 -init -bias PlateId [-9999]: cameraData(exec_boot) does not exist!!!!!!! camstat does not seem to have worked Flushing charge for 15 sec appending BEGIN appending END EXPOSURE TIME is: 0 997771307 997771307 The old teamster, PID 1466794, appears to have died; restarting Seq 10530 Exp 10530 Frame 10530 Do not schedule startFlushCharge sp1 200 sp2> However, the bias image did read out. Do not schedule startFlushCharge sp2 200