compass.ocean.tests.drying_slope.default.Default¶

class compass.ocean.tests.drying_slope.default.Default(test_group, resolution, coord_type)[source]¶

The default drying_slope test case

Variables:

resolution (float) – The resolution of the test case in km
coord_type (str) – The type of vertical coordinate (sigma, single_layer, etc.)

__init__(test_group, resolution, coord_type)[source]¶

Create the test case

Parameters:

test_group (compass.ocean.tests.drying_slope.DryingSlope) – The test group that this test case belongs to
resolution (float) – The resolution of the test case in km
coord_type (str) – The type of vertical coordinate (sigma, single_layer)

Methods

`__init__`(test_group, resolution, coord_type)	Create the test case
`add_step`(step[, run_by_default])	Add a step to the test case
`check_validation`()	Check the test case's "validation" dictionary to see if validation failed.
`configure`()	Modify the configuration options for this test case.
`run`()	This method is deprecated.
`validate`()	Validate variables against a baseline