During opening, we again saw the secondary E axis Galil fail to stop on a full 
step, despite further work on the Galil by Jon B. and Wendell this afternoon,
after which Steph and Russell exercised the secondary without incident.  The first
time we homed the axis, tcc_prim reported a 148 microstep error.  We immediately
saw the same problem as soon as we re-enabled the collimate process again.  This
time, homing showed a 1 microstep error.  We did not see the problem again during the
night.

In pursuit of the source of the difference between the two pointing models taken
this run, Robert and Steph verified that the same fiducial tables were used, and
Craig and Russell eliminated axisDtime errors and problems with the earth 
orientation data block as possible causes.  The mystery continues.


We opened at 20:30 under partly cloudy skies.  After fixing the problem with the
secondary, we attempted spectroscopy, starting with the pointing model of last
night.  

Plate 627, cartridge 1.  No stars in guide fibers after initial gotoField.  The first
fk5InFiber produced bizarre behavior.  The field was at (RA, Dec) = (313, -6).  The
track to the fk5 aimed at (260, 47)!!!

Cart 1, no star with either model.

Cart 3.  field at ra=313, dec=-6.  fk5infiber went to 260 +47?  second fk5infiber went
to nearby star.  Offset ra+12, dec+2 to center star, then we got guide stars.  


Spectro 1 fill faults at 22:19 did not correspond to actual warming.  

Closed by high humdity at 00:05 MDT.

i+trim2 reported  -6.68V for CCD61.  Watched seemed to report this about midnight (while
we were closing), but a plot showed this had been the value since 10am this morning.